When your system quits, you need heating and cooling repair near me Hunters creek FL that actually shows up. Revixa Tech sends licensed techs to Hunters creek homes for AC, furnace and heat pump failures, usually the same day you call. We diagnose with manifold gauges and a multimeter, quote the fix upfront, and get your air moving again.
heating and cooling repair near me Hunters creek FL is the diagnostic and repair work that gets a failed AC, furnace or heat pump running again. It covers refrigerant leaks, dead capacitors and contactors, blower motor failure, clogged air filters, dirty evaporator coils and faulty thermostats. Our techs test the system with manifold gauges and a multimeter, recover refrigerant with a recovery machine, then repair or replace the failed part and verify airflow before we leave.
Hunters creek homes run their AC nine months a year, and that runtime wears parts out fast. A capacitor that fails in July leaves you in a 90-degree house by dinner. We handle emergency heating and cooling repair Hunters creek FL calls around the clock, and we keep common parts for Carrier, Trane, Lennox, Goodman and Rheem systems on the truck so most jobs finish in one visit.
Every repair call includes a full diagnostic, an upfront quote, the repair itself, and a system test before we leave. Parts and labor are covered by our 1-year workmanship warranty. If we find something outside the scope of the repair, we tell you and quote it separately so you can decide.
We test refrigerant charge with manifold gauges, check the capacitor and contactor with a multimeter, inspect the evaporator coil, and check airflow. Takes 45 to 60 minutes and ends with a written finding.
You get the price before we start. The $89 diagnostic comes off the bill when you approve the repair. No hourly billing, no surprise line items on the invoice.
We stock capacitors, contactors, blower motors, thermostats and common refrigerant types on every truck. Most repairs finish in one visit without a parts order in between.
If the sealed system is open, we recover refrigerant with a recovery machine, repair the leak, and recharge to spec. We handle R-410A and R-32 systems and follow EPA Section 608 rules on every job.
We run the system 20 to 30 minutes and check temperature split and static pressure. If the numbers are not right, we keep working until they are. No leaving a job half-tested.
Every repair carries a 1-year workmanship warranty on top of the manufacturer parts warranty. If the same failure comes back within that year, we come out and fix it at no charge.
Call (844) 796-4282 or book online. We ask what the system is doing, how old it is, and whether it is blowing warm or not at all. You get a two-hour arrival window, and we text when the tech is on the way.
The tech checks refrigerant charge with manifold gauges, tests the capacitor and contactor with a multimeter, and inspects the evaporator coil and air filter. A standard diagnostic takes 45 to 60 minutes and ends with a written finding.
You get the repair options and the price in plain language. We explain what failed, why it failed, and whether a repair or replacement makes more sense. Nothing gets done until you say go.
We recover refrigerant with a recovery machine if the sealed system is open, braze in new copper tubing, swap failed parts, and recharge to spec. Then we run the system 20 to 30 minutes and check temperature split and static pressure.
Before we pack up, the tech shows you what was replaced, sets your thermostat, and tells you what to watch for. You get the invoice, the warranty terms, and a filter size written down so the next change is easy.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Read high-side and low-side refrigerant pressure to confirm charge and spot restrictions in the sealed system.
Test capacitors, contactors, motors and control boards to find the exact failed component instead of replacing parts by guess.
Recover refrigerant safely before opening the sealed system, in line with EPA Section 608 rules.
Pull a deep vacuum on the system after a repair to remove moisture and air before recharging.
Test gas furnace combustion and flue gases to confirm safe operation after a repair.
Clean ductwork and remove built-up dust and debris that restricts airflow and strains the blower.
Cut and flare copper tubing cleanly when replacing a failed line or brazing in a new component.
A Hunters creek homeowner called on a Friday in July. The AC was running but blowing warm air, and the house had climbed to 87 degrees. The system was a 9-year-old Goodman with a failed run capacitor and a dirty evaporator coil.
We swapped the capacitor, cleaned the evaporator coil, and recharged the system to spec. Temperature split went from 8 degrees to 20 degrees, and the house was back to 74 by early evening. Total time on site: three hours.
A Westchase homeowner lost heat on a cold night in January. The heat pump was running but blowing cold air. Our tech found a failed reversing valve and a defrost board that was not cycling properly.
We replaced the reversing valve, swapped the defrost board, and recharged the system with R-410A. Heat was back on within four hours of arrival, and the system held temperature through the rest of the cold snap.
A Memorial homeowner complained about weak airflow in two bedrooms and a power bill that had jumped $90 over three months. The blower motor was working hard, and static pressure was well above spec. We found duct leakage in the attic run.
We sealed the duct leakage, cleaned the evaporator coil, and replaced a clogged air filter. Static pressure dropped back into range, and airflow at the far vents improved noticeably. The next power bill came in $60 lower.
Most calls come down to a handful of failures. Here are the ones we see most in Hunters creek, what happens if you wait, and how we handle them.
Ask a pro →We check refrigerant charge, capacitor, contactor and evaporator coil. Most warm-air calls trace to a failed capacitor or a low charge from a slow leak. We fix the failed part, find and repair the leak, and recharge to spec.
We test ignition, flame sensor and gas pressure with a combustion analyzer. Common fixes are a dirty flame sensor, a failed ignitor or a bad control board. We test the heat exchanger before we call the job done.
We check the filter, inspect the evaporator coil, and test static pressure. If duct leakage is the issue, we seal it. If the blower motor is failing, we swap it. Most airflow problems clear up in one visit.
We check thermostat calibration, refrigerant charge and the compressor. A faulty thermostat or an overcharged system are the usual culprits. We fix the cause, not just the symptom, and verify the system runs a full cycle before we leave.
Most repairs in Hunters creek run $180 to $650 in 2026, depending on the part and how long the job takes. A capacitor or contactor swap sits at the low end. A blower motor, refrigerant leak repair or compressor replacement pushes higher. Diagnostic is $89 and comes off the bill when you approve the repair.
Revixa Tech does, and we are local to Orange County. We have been repairing HVAC systems in Hunters creek since 2022, with NATE-certified techs and EPA Section 608 certification for refrigerant work. Call (844) 796-4282 and we will get a tech to your door, usually the same day.
Same-day for most calls booked before 2 p.m. Standard repairs take two to four hours on site. If we need a part we do not stock, we usually have it within 24 hours. Emergency calls after hours get priority dispatch, and we aim for a 90-minute arrival window on those.
Yes. Our line is live 24 hours a day, seven days a week, including holidays. Summer AC failures and winter furnace failures both get answered. Call (844) 796-4282 any time and a real person picks up, not a machine.
furnace repairWhen your furnace quits on a cold January morning, we diagnose ignition failure, flame sensor issues and blower problems. Most furnace repairs in Hunters creek finish the same day, and we test the heat exchanger before we call it done.Explore →
air conditioning repairAC not cooling is our most common summer call in Hunters creek. We check refrigerant charge, capacitor, contactor and evaporator coil, then fix what failed. Most AC repairs are done in one visit with parts off the truck.Explore →
furnace replacementWhen a furnace is past 15 years or the heat exchanger is cracked, replacement beats repair. We size the new unit to your home with an ACCA load calculation and haul the old one away. Most swaps finish in a day.Explore →
air duct cleaningDusty vents and weak airflow often trace back to duct buildup. We clean the ductwork with a duct cleaning machine and check for duct leakage while we are in the attic. Cleaner ducts mean better airflow and lower bills.Explore →
heating repairHeat pump or furnace not heating is a safety issue, not just a comfort one. We test the combustion analyzer on gas units, check the reversing valve on heat pumps, and get heat back on the same day in most cases.Explore →
heat pump repairHeat pumps work year-round in Hunters creek, which means more wear. We diagnose reversing valve failures, defrost board issues and refrigerant leaks. Most heat pump repairs finish in two to four hours on site.Explore →
emergency HVAC repairNo AC in August or no heat in a cold snap is an emergency. We run 24/7 dispatch for Hunters creek and surrounding areas, with a 90-minute arrival target on after-hours calls. Call (844) 796-4282 any time.Explore →
AC repairWarm air, weak airflow or a system that short-cycles all point to AC trouble. We test the full system, find the failed part, and fix it. Most AC repair calls in Hunters creek are handled the same day you call.Explore →Call (844) 796-4282 and we will get a licensed tech to your door, usually the same day. Upfront pricing, 1-year workmanship warranty, and a real person on the line 24/7.
Book a Repair (844) 796-4282 →Call (844) 796-4282 any time, day or night. A live dispatcher answers, takes your address and symptoms, and gives you an arrival window. For non-emergency work, we schedule same-day and next-day slots across Hunters creek and the surrounding neighborhoods, and we text you when the technician is on the way.