AC runs all day and never hits setpoint
We measure actual capacity against the rated tonnage. If the unit is more than 12 years old and running below 80% of rating, we quote a correctly sized replacement with a load calculation to match.
Licensed, insured, and built for Florida heat
HVAC replacement Hunters creek FL done right the first time
When your old system quits, HVAC replacement Hunters creek FL homeowners can count on starts with a straight answer, not a sales pitch. We size the new unit to your home, pull the permit, and install it to Florida code. Whether you need HVAC installation Hunters creek wide or a quick swap before summer, our techs handle Carrier, Trane, and Daikin systems daily.
Careful work. Honest options.
About this service
What HVAC replacement Hunters creek FL really involves
HVAC replacement Hunters creek FL is the full removal and reinstallation of your home's heating and cooling equipment, including the condenser, air handler, line set, and thermostat. It is not a repair. When your compressor fails at 14 years old or your refrigerant leak keeps coming back, replacing the system usually costs less over five years than chasing parts. We recover the old refrigerant, dispose of the equipment, and commission the new unit so it runs at its rated efficiency from day one.
Hunters creek homes take a beating from heat and humidity. Most of the housing stock here was built in the 1990s and 2000s, so the original systems are hitting the end of their service life right now. If your unit runs all day and never hits the setpoint, or your energy bill jumped $80 last month, it is time for a real conversation. We offer affordable HVAC replacement in Hunters creek with options for every budget.
- ✓ Lower monthly bills
- ✓ Cooler rooms, faster
- ✓ Fewer breakdowns
- ✓ Better air quality
What's included
What is included in HVAC replacement
Every replacement includes the equipment, labor, permit, and commissioning. Here is what you get in the base price, and what we quote separately if your home needs it.
✓
New condenser and air handler
Matched indoor and outdoor units from the same manufacturer line, sized to your home's Manual J load. Includes a new thermostat, filter rack, and vibration pads under the condenser.
✓
Line set and drain
New copper tubing, brazed and pressure-tested, with a fresh PVC condensate drain and float switch. We replace the line set on most jobs because reusing old copper is the number-one cause of slow refrigerant leaks.
✓
Electrical and permit
New disconnect box, whip, and breaker sized to the equipment. We pull the Orange County permit in our name, schedule the inspection, and hand you the signed-off paperwork when it passes.
✓
Commissioning report
We measure static pressure, temperature split, and airflow at every register, then record the readings on a signed checklist. You get a copy for your records and your warranty file.
✓
Haul-away and disposal
We recover the old refrigerant with an EPA-compliant recovery machine, then remove the condenser, air handler, and any scrap copper or old duct material. Your yard is left clean.
✓
Warranty registration
We register your equipment with the manufacturer the same week, which keeps the 10-year parts warranty valid. Our 5-year workmanship warranty is documented on your invoice.
How it works
How our replacement process works
01
Load calculation
We measure every room, check window orientation, insulation, and duct sizing, then run a Manual J load calculation. This takes 45 to 60 minutes and tells us the exact tonnage your home needs. Guessing here is why so many systems short-cycle and fail early.
02
Upfront quote
You get a written price the same day, broken down by equipment, labor, permit, and any duct work. We show you two or three options across Carrier, Trane, Goodman, and Daikin so you can pick your efficiency level. No pressure, no same-day-only discounts.
03
Permit and scheduling
We pull the HVAC permit through Orange County and schedule your install, usually within 3 to 7 days. If your system died and you cannot wait, we offer same day HVAC replacement Hunters creek service when equipment is in stock.
04
Install day
A two-man crew arrives at 8 a.m. and finishes most swaps in 6 to 9 hours. We recover the old refrigerant with a recovery machine, cut and braze new copper tubing, set the pad, wire the thermostat, and pressure-test the line set before charging.
05
Commission and walkthrough
We verify airflow at every register, check the temperature split, and set your Nest or Ecobee schedule. Then we walk you through the system, show you the filter location, and register your warranty. You get a signed checklist before we leave.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Manifold gauges
Used to read suction and liquid line pressures during charging. Accurate pressures are how we verify the system has the correct refrigerant charge for the line set length and indoor conditions.
Vacuum pump and micron gauge
We pull a deep vacuum on every new line set and hold it under 500 microns before opening the valves. Skipping this step leaves moisture in the system and kills compressors early.
Recovery machine
EPA Section 608 requires refrigerant recovery before disposal. We recover R-410A and R-32 from every old system and document the amount, so nothing vents to atmosphere.
Combustion analyzer
On gas furnace replacements, we measure CO, O2, and flue temperature to confirm safe combustion. This is a required step on every gas-fired install in Orange County.
Multimeter and clamp meter
We verify voltage, capacitance, and amp draw on the compressor, blower, and contactors. This catches weak capacitors and undersized breakers before they cause a callback.
Flaring tool and tube cutter
Clean, square cuts and properly torqued flares prevent the refrigerant leaks that plague sloppy installs. We use these on every mini-split and tight-clearance line set.
Duct cleaning machine
When we find heavy debris or mold in the ductwork, we clean it before connecting new equipment. New systems on dirty ducts lose capacity and clog filters within weeks.
Real results
Before and after.
18-year-old Carrier swap in Hunters Creek
Before
A 3-ton Carrier condenser from 2007 was short-cycling and could not hold 78 degrees on a 95-degree afternoon. The homeowner had paid for two refrigerant recharges in 18 months, totaling $740, and the electric bill had climbed to $310 per month.
After
We installed a matched 3-ton 16-SEER2 Trane system with a new line set and media filter. The house now holds 74 degrees with the thermostat set at 76. First full-month electric bill came in at $218, a $92 drop.
Heat pump upgrade in Bunker Hill Village
Before
A 15-year-old 4-ton heat pump was struggling in both summer and winter. Winter bills hit $280, summer bills hit $340, and two rooms upstairs stayed 5 degrees warmer than the rest of the house.
After
We replaced the system with a variable-speed Mitsubishi Electric heat pump, added a zone damper to the upstairs run, and sealed 14 feet of leaking duct. Room-to-room temperature variance dropped to 1 degree, and combined annual energy cost fell about 25%.
Three-unit rental turnover in Memorial
Before
A property manager had three duplex units with 2004 Goodman systems that failed inspection for refrigerant leaks. Tenants were complaining about warm bedrooms, and two lease renewals were at risk.
After
We replaced all three systems with matched 2.5-ton Rheem units over four days, pulled one permit per unit, and passed inspection on the first visit. All three tenants renewed, and the owner financed the project over 36 months at $410 per month.
Problems we solve
Problems we solve with HVAC replacement
Some failures are worth repairing. Others mean the system is done. Here are the situations where replacement is the smarter money.
Ask a pro →↗
Refrigerant leak that keeps coming back
We leak-test the coil and line set. If the leak is in the evaporator coil on an older system, replacement usually beats a $1,800 coil swap on a unit that is already near end of life.
Compressor failure on a 12-year-old unit
We quote both options side by side. In most cases, a full HVAC replacement in Hunters creek Florida makes more sense because you get a new warranty, new efficiency, and no second failure waiting to happen.
Hot and cold rooms through the house
We run a room-by-room load calculation and check duct static pressure. The replacement quote includes duct corrections where needed so every room gets the airflow it should.
Proof you can check
Licensed, certified, and reviewed
✓
Florida HVAC Contractor LicenseFlorida Department of Business and Professional Regulation
✓
NATE CertificationNorth American Technician Excellence
✓
EPA Section 608 CertificationU.S. Environmental Protection Agency
✓
ACCA MembershipAir Conditioning Contractors of America
✓
AHRI CertificationAir-Conditioning, Heating, and Refrigeration Institute
Most full replacements in Hunters creek run $5,800 to $11,500 in 2026, depending on tonnage, efficiency rating, and whether duct work is needed. A basic 3-ton 14.3-SEER2 system sits near the low end; a 5-ton variable-speed heat pump with new ductwork lands at the top. We give you a written range before any work starts.
A standard swap takes 6 to 9 hours, so most homes are back to full cooling the same day. If we are adding new duct runs, a plenum rebuild, or a heat pump conversion, plan for two days. We schedule morning starts so you are never left overnight without air in the middle of summer.
Size depends on square footage, ceiling height, window area, and insulation, not just the number on your old unit. A 1,500 sq ft home here usually needs 2.5 to 3 tons; a 2,400 sq ft home typically needs 4 to 5 tons. We run a Manual J load calculation on every quote so you get the right tonnage.
Yes. We offer approved financing with terms from 12 to 84 months, including 0% promotional plans for qualified buyers. Most customers put nothing down and pay between $95 and $210 per month. Ask about financing when you book the quote and we will run the numbers with your equipment options.
More services
Related Services
furnace repairIf your furnace is limping through winter, we diagnose ignition, blower, and gas valve issues before you commit to a full replacement. Many Hunters creek homeowners pair a furnace repair with a new AC install to save on labor.Explore →
air conditioning repairNot every failing system needs replacement. We check capacitors, contactors, refrigerant charge, and compressor health first. If a $300 repair buys you three more years, we will tell you straight instead of pushing a new unit.Explore →
furnace replacementWhen your furnace is past 15 years or the heat exchanger is cracked, replacement is the safe call. We install gas and electric furnaces sized to match your existing ductwork and new AC condenser for a balanced system.Explore →
air duct cleaningNew equipment on dirty ducts loses efficiency fast. We clean supply and return runs, sanitize the plenum, and seal leaks before or after your HVAC replacement so your new system breathes clean air from day one.Explore →
heating repairFlorida winters still drop into the 30s, and a dead heat strip or faulty thermostat leaves you cold. We repair gas, electric, and heat pump heating systems across Hunters creek, often the same day you call.Explore →heat pump repairHeat pumps handle both heating and cooling, so a failure hits year-round. We service reversing valves, defrost boards, and refrigerant circuits on all major brands, and we can convert your system to a heat pump at replacement time.Explore →
emergency HVAC repairWhen your AC dies at 10 p.m. in July, we answer. Our emergency line runs 24/7, and we stock common parts like capacitors, contactors, and blower motors so most emergency calls are fixed on the first visit.Explore →
AC repairWeak airflow, warm vents, or a unit that will not start usually means a repairable fault. We test the full system with manifold gauges and a multimeter, then give you a clear repair-or-replace recommendation with pricing for both.Explore → Ready when you are
Get your HVAC replacement Hunters creek FL quote today
Call (844) 796-4282 and we will schedule a same-day assessment with a written price. Licensed, insured, and warrantied for five years on labor. If your system is down, tell us and we will prioritize the call.
Get Free Quote (844) 796-4282 →
Request an appointment
Get in touch with us
Call (844) 796-4282 any time, day or night. A live dispatcher answers, takes your address and symptoms, and gives you an arrival window. For non-emergency work, we schedule same-day and next-day slots across Hunters creek and the surrounding neighborhoods, and we text you when the technician is on the way.
Call anytime(844) 796-4282Email the office[email protected]
Office hoursOpen 24 hours · 7 days a week